GAI-Tronics MRTI 2000 (No. PL1877A) Microprocessor Radio Telephone Interconnect Installation & Service Manual - Manual (Page 29)

PL1877A Microprocessor Radio Telephone Interconnect PC Programming
23 12/10
Input/Output – I/O Settings - Read Remote
For Remote Programming, it is recommended that you have a telephone connected to the modem, or a
modem with a speaker to monitor the connection process.
Call Waiting
If a modem is used, and the phone line being used has a Call Waiting feature, this feature must be
disabled in the IAPS programming.
• To disable call waiting, enter *70. Although this is the standard Disable Call Waiting code, some
local phone companies may use a different code. To verify *70 as the correct code, dial it on a phone
connected to the phone line you will be calling from.
• A beep signifies it is the correct code.
• A busy signal means the code does not work. Check your phone book or call your local telephone
company for information,
Paging
If the Paging option is enabled, these parameters must be set:
• Click on Access/Release under the main menu and select Telephone Init. Enable Require * from
Telephone User for Direct Access for Line 1 and Line 2.
• Click on Basic Operational Settings and select Programming Privileges.
Enter the prefix to *#0 Telephone Line Programming Code - (Enter a code here if you want only
those with an access code to be able to access the PL1877A parameters remotely. This code number
must be entered as the Telephone Line Dialing Prefix, or the connection attempt will fail.)
After Call Waiting and Paging options have been programmed go to the Input/Output on the Main Menu.
Select Program, then click on Program Remote. The Dialing Screen appears. Select the desired
dialing method.
If you want the computer to dial the PL1877A Interconnect phone number, select Enter Number. Type
the PL1877A Interconnect telephone number at the Enter Number prompt. If applicable, enter the land-
line access code.
If the PL1877A has a Remote Access Code, enter that number in the Land-Line Dialing Prefix field.
Click on Dial. After the modem dials the number, listen for the remote PL1877A to answer. If using a
telephone connected to the modem, pick up the telephone receiver and listen for the remote PL1877A to
answer.
If dialing from a telephone connected to the modem, click on Manual Dialing, pick up the telephone, and
dial the number of the remote PL1877A. Click on OK when the PL1877A connects, and then hang up.
To ensure your parameters are saved after your programming session, make sure the Auto Archive box is
checked.