GAI-Tronics MRTI 2000 (No. PL1877A) Microprocessor Radio Telephone Interconnect Installation & Service Manual - Manual (Page 46)

PC Programming PL1877A Microprocessor Radio Telephone Interconnect
12/10 40
DTMF On Time for Telephone Line Dialing
Selects the DTMF digit On-Time (i.e. the duration of the regenerated DTMF burst) sent to the telephone
network during dialing. The valid range is 50–450 ms. Adjustable on-time allows the interconnect to
work with telephone systems that require longer DTMF bursts. This parameter is only available if the
Land-Line Signaling Type is set to DTMF.
Rotary Pulse Dial Rate
This is only available if the Land-Line Signaling Type is set to Pulse.
Mobile Audio Cut-Through Delay
Alters DTMF interdigit time allowed to mobile users during manual dialing. After the time expires,
receive audio is cut-through to the landline party.
This timer prevents direct pass-through of DTMF digits from the mobile, (i.e. non-regenerated) which
can cause wrong numbers to be dialed.
Signaling – Telephone Line Dialing -Autodial/Redial
Autodial Feature Enabled
Determines whether a mobile can use the Auto-dial feature. If disabled, the mobile can only dial phone
numbers manually.
Restrict Mobile Users to Autodial Numbers
Restricts mobile users to using only the autodial feature when dialing telephone numbers. This equates
to placing a restriction on manual dialing telephone numbers for mobile users.
Mobile Modifications of Autodial Numbers
Determines whether mobiles are allowed to modify autodial numbers.
Redial
May be enabled or disabled. The last number dialed is automatically re-dialed if enabled when the
mobile accesses the interconnect with a ** command instead of a single *. Any applicable multi-digit
prefix must still be entered from the mobile.
Autodial Number Pause Time
Sets the duration of the pause in dialing that occurs whenever a pause character is encountered in an
autodial number.