GAI-Tronics MRTI 2000 (No. PL1877A) Microprocessor Radio Telephone Interconnect Installation & Service Manual User Manual
Page 71
PL1877A Microprocessor Radio Telephone Interconnect Operator Instructions
65
12/10
The following is a list the mobile commands:
Abbreviated Mobile Commands Chart
N
OTE
: All multi-digit commands must be entered with a maximum of 1 second inter-digit time.
Standard Commands
* (or #*)
Access telephone line (#* if set by parameters)
# (or ##)
Release telephone line (## if set by parameters)
**
Redial last number called
***
Overrides line busy
***
After access = refresh/reset overall access timer
n**#
Station/repeater enable command (n = station/repeater enable prefix)
*#*
Before access = answer if called (special applications
*#*
After access = flash (momentary on-hook to regain dial tone where applicable
*1*
TX PL tone on
*1#
TX PL tone off
n*
Multi-digit access code: n = 1–6 digits
#n
Multi-digit access code: n = 1–6 digits
*0#n
Executive override code: n = 1–6 digits (overrides a variety of programmed
restrictions
n*#0
Enter mobile, DTMF programming mode (n = remote parameter access code, 1–6
digits)
Auto-dial
*1
Patch dials stored telephone number 1
*9
Patch dials stored telephone number 9
*25
Patch dials stored telephone number 25
*0*
Enter autodial programming mode
Selective Signaling Option
*##n
Revertive (mobile-to-mobile) call where n is the capcode or user ID of the target
mobile
2nd Line Option
*2*
Select line 2 for outbound call origination
*2#
Select line 1 for outbound call origination (if line 2 is currently selected)