Gasboy Fuel Point PLUS Vehicle - Manual (Page 103)

Fuel Point PLUS Vehicle Installation and Configuration Manual 103
Table 4-14. DP Light Programming Sequence – Pulses Interface
Step Display Description/Action
20 Odometer reading option. Default: Y
Press ENTER to collect odometer reading
Change default to N to disable the option.
21 Distance measurement units' definition: 1 for Km.
or 2 for Miles. Default: Miles. Save or edit the
parameter and save.
In cases where the Odometer reading option
was disabled, proceed to Step 25
22 Set the Odometer factor
23 Set the Odometer threshold
24 Set the Odometer hysteresis
25 E.H. reading option. Default: Y
Press ENTER to collect E.H. reading
Change default to N to disable the option
26 This screen is displayed only in cases where
Odometer reading was not disabled.
Edit the parameter, entering the value displayed
on the dashboard
27 This screen is displayed only in cases where
E.H. reading was not disabled.
Edit the parameter, entering the value displayed
on the dashboard (if available)
28 Switch Timeout. Default: 30 Minutes. Save or
edit the parameter and save