Gasboy Fuel Point PLUS Vehicle - Manual (Page 31)

Fuel Point PLUS Vehicle Installation and Configuration Manual 31
8. The unit is handled and carefully, avoiding mechanical pressure on the chip. Improper
handling could damage the unit and cause malfunction
9. In long neck installations, an additional metal band is tied under the installed coil to prevent
the coil from sliding down and guarantee extra safety.
2-6.3.
Required Tools
Cutter
Crimping tool
Pliers
Isolation tape
0.5" (13mm) wrench key
Soldering iron
Soldering tin
CV joint banding tool and cuter (see Figure 2-15)
Figure 2-15. CV Joint Banding Tool and Cutter
2-6.4.
Coil Installation
2-6.4.1. Long Neck Fuel Inlet Installation Procedure
This installation method is implemented in fuel tanks where the fuel tank inlet protrudes sufficiently
from the fuel tank surface. It makes use of vertical positioning of the molded coil clamps.
Proceed as follows:
1. Place an adequate number of clamps evenly around the coil (use three to five clamps per
coil size). Make sure that the clamps are positioned vertically (see Figure 2-16)