Gasboy Fuel Point PLUS Vehicle - Manual (Page 36)

Fuel Point PLUS Vehicle Installation and Configuration Manual 36
3. Connect the ID chip wires to the coil wires after cutting the chip’s connector by
soldering them or using connection terminals (Conn end. Wire ETC EC-2), or any other
suitable connection
4. Verify that the ID chip is programmed with correct data, using the Wireless Programmer
5. Glue the ID chip inside the Security cover (see Figure 2-22)
Figure 2-22. ID Chip Installed in a Security Cover
6. Attach the security cover to a free hole in the vehicle chassis using the ~0.33" (8mm)
dedicated screw
7. If there are not unoccupied holes, create a ~0.33" (8mm) thread hole using a tap in any
available bar and attach the security cover as shown in Figure 2-23
Figure 2-23. Attaching the Security Cover to a Bar
8. Tighten the screw until its head is broken; the Security cover and the ID chip are now
fully secured and cannot be removed from the vehicle.