Gasboy Fuel Point PLUS Vehicle - Manual (Page 26)

Fuel Point PLUS Vehicle Installation and Configuration Manual 26
Figure 2-9. Inserting One-Way Screw
c. Apply instant glue to the back part of the ID chip (see Figure 2-10)
Figure 2-10. Applying Adhesive
d. Secure the screw into position in the space prepared, without applying too much
pressure on the screw. Make sure to go through all the instructions in order to
prevent malfunction
e. Spray instant glue accelerator - Activator, pronto, 60ml (3M) around the glued
area
NOTE
When installing the Shaped coil, first connect the ID
chip to the coil.
7. After connecting the coil to the ID chip, to avoid corrosion caused by humidity and
accumulation of fluid at the connection area (shaped coil only), it is recommended to:
seal the connector's area by applying dual component glue DP-805NS (3M), or neutral
silicon on top of the connectors such as Terostat939, or Holdtite HNCS