Gasboy Fuel Point PLUS Vehicle - Manual (Page 32)

Fuel Point PLUS Vehicle Installation and Configuration Manual 32
Figure 2-16. Positioning the Clamps
2. Remove the fuel inlet cover
3. Tighten the clamps to the fuel tank inlet using the stainless steel clamp band: insert the
clamp band into the designated slots of the clamps. Fasten the metal band firmly to
avoid future sliding of the Fuel Ring using the joint banding tool and cuter (see
Figure 2-17)
NOTE
Before tightening the metal band, raise the coil as
much as possible to bring it close to the fuel inlet
(less than 3cm) and verify that the coil does not
interfere with the opening and closing of the fuel
tank inlet cover.