Gasboy Fuel Point PLUS Vehicle - Manual (Page 49)

Fuel Point PLUS Vehicle Installation and Configuration Manual 49
Figure 3-8. Pluging the μDataPass
4. Tighten the µDataPass in place using a finger (see Figure 3-9)
Figure 3-9. Tightening the μDataPass
5. Re-assemble the board covering the Diagnostics connector.
3-5.3.
Installing the DataPass
NOTE
µDataPass installation is the preferred solution for
light vehicles, so the following procedure is rare and
conducted in cases where µDataPass cannot be used.
When access to the rear Diagnostics connector is
problematic, the Adaptor Plug is used (see Para. 3-
5.3.1). In cases where the vehicle Bus cannot be
located, find an Odometer pulses source and connect
to the DataPass.
The DataPass is connected to the Diagnostics connector (see Figure 3-10, Figure 3-11 and
Table 3-8) using the DataPass Harness, exposing the Diagnostics connector's wiring and welding
each of its wires to the corresponding wire in the DataPass Harness as specified in Table 3-8.