Gasboy Fuel Point PLUS Vehicle - Manual (Page 90)

Fuel Point PLUS Vehicle Installation and Configuration Manual 90
Step Display Description/Action
30 This screen is displayed in cases where E.H.
reading was disabled (Step 22) or the E.H. source
selected was Switch (Step 23).
Main Engine Address (Default: 255) and DP
Source Address (Default: 141) Save or edit the
parameters and save
If programming DP (not DP+), proceed to
Step 51
31 Error codes collection option. Default: N
Press ENTER to leave the option disabled
Change default to Y to enable the option
32 Aux. Engine #1 E.H. reading option. Default: N
Press ENTER to leave the option
disabled. In this case, proceed to Step 37
Change default to Y to enable the option
33 Select the input source for Aux. #1 Engine Hour
reading: 1 for Line or 2 for Vehicle Bus. Default:
Bus
Press ENTER to select BUS. In this case,
proceed to Step 35
Change default to 1 to select Line. In this
case, proceed to Step 34
34 Select the line polarity: 1 for Minus, 2 for Plus.
Default: Plus
Press ENTER to select Plus
Change default to 1 to select Minus
Proceed to Step 36
35 Aux. Engine #1 E.H. Address (Default: 175).
Save or edit the parameter and save