Gasboy Fuel Point PLUS Vehicle - Manual (Page 130)

Fuel Point PLUS Vehicle Installation and Configuration Manual 130
Table A-2. DP Calibration Sequence
Step Display Description/Action
1 Enter User ID
Enter password.
2 The Main Menu is displayed.
3 Use the DOWN arrow key to move the pointer
(>) to the Calibrate DP option
4 Use the DOWN arrow key to move the pointer
(>) to the Read DP by Address option
6 DP MAC address (unique unit ID) insertion:
Enter 1 to automatically recognize DP MAC
address. Stay inside the vehicle close to DP,
or at a maximum range of ~0.5m to maintain
proper receiving signal and avoid the
possibility of finding by mistake another DP.
Wait up to seven seconds for result
Enter 2 for manual insertion of the MAC
address
7 Verify the automatically entered MAC/Type the
eight characters as shown on DP rear label and
save
8
Wait a few seconds until the WP recognizes the
DP
9
Enter the current odometer reading