Gasboy Fuel Point PLUS Vehicle - Manual (Page 34)

Fuel Point PLUS Vehicle Installation and Configuration Manual 34
Figure 2-19. Securing Clamps on Short Neck Inlet
3. Using the pistol grip (or pliers), pull the metal wire and twist it until the molded coil
clamps are firmly fastened to the truck's fuel tank inlet. Please note that fastening the
metal wire too strongly may tear the molded coil clamps or wire, while fastening it too
weakly may cause the coil to slide
NOTE
Before tightening the metal band, raise the coil as
much as possible to bring it close to the fuel inlet
(less than 30mm) and verify that the coil does not
interfere with the opening and closing of the fuel
tank inlet cover.
4. After tightening the metal wire, cut the redundant part of the wire using a cutter.
5. Insert the coil into the molded clamps as shown in Figure 2-20