Gasboy Fuel Point PLUS Vehicle - Manual (Page 91)

Fuel Point PLUS Vehicle Installation and Configuration Manual 91
Step Display Description/Action
36 Aux. Engine #1 E.H. reading is displayed, in
cases where the E.H. source is the Bus.
Otherwise, a zero is displayed.
Edit the parameter, entering the value displayed
on the dashboard (if available)
37 Aux. Engine #2 E.H. reading option. Default: N
Press ENTER to leave the option
disabled. In this case, proceed to Step 42
Change default to Y to enable the option
38 Select the input source for Aux. #2 Engine Hour
reading: 1 for Line or 2 for Vehicle Bus. Default:
Bus
Press ENTER to select BUS. In this case,
proceed to Step 40
Change default to 1 to select Line. In this
case, proceed to Step 39
39 Select the line polarity: 1 for Minus, 2 for Plus.
Default: Plus
Press ENTER to select Plus
Change default to 1 to select Minus
Proceed to Step 41
40 Aux. Engine #2 E.H. Address (Default: 183).
Save or edit the parameter and save
41 Aux. Engine #2 E.H. reading is displayed, in
cases where the E.H. source is the Bus.
Otherwise, a zero is displayed.
Edit the parameter, entering the value displayed
on the dashboard (if available)
42 Power take-off operating hour's collection
option. Default: N
Press ENTER to leave the option disabled
Change default to Y to enable the option