Gasboy Fuel Point PLUS Vehicle - Manual (Page 84)

Fuel Point PLUS Vehicle Installation and Configuration Manual 84
Parameter Description
Odometer Address Source address for odometer reading in the vehicle
communication protocol. Default is 255 and should be
changed only in cases where odometer was not
successfully read or another value was provided by the
client
DP Odometer
Address
Address assigned in the vehicle communication
protocol to the DP for obtaining odometer reading.
Default is 141 and should be changed only in cases
where odometer was not read or another value was
provided by the client
Distance Unit Distance measurement units' definition for calculations
and reports
EH Source Physical source of E.H. reading: Vehicle switch or bus
E.H. Address Source address for E.H. reading in the vehicle
communication protocol. Default is 255 and should be
changed only in cases where E.H. was not successfully
read or another value was provided by the client
DP E.H. Address Address assigned in the vehicle communication
protocol to the DP for obtaining E.H. reading. Default
is 141 and should be changed only in cases where E.H.
was not read or another value was provided by the
client
E.H. PID E.H. Parameter ID. The code used to request E.H. data
from the vehicle. Default is 247 and should be changed
only in cases where E.H. was not read or another value
was provided by the client
Engine On Report Reports on Main Engine operation status (ON/OFF), as
may be required to comply with local regulations
forbidding refueling while vehicle's engine is ON
MAC Address Unique identifier assigned to the DP/μDP unit. The
MAC appears on the unit's back label.
Main Engine The source engine for Idle Time, Over Speeding, Over
RPM and Fuel Level data collection
Switch Time Out Period of time in which the DataPass remains active
after the vehicle is switched off. Default is 30 minutes
Odometer Factor Number of pulses indicating a distance unit (mile or
Km), as provided by the vehicle manufacturer.