Gasboy Fuel Point PLUS Vehicle - Manual (Page 18)

Fuel Point PLUS Vehicle Installation and Configuration Manual 18
815202401 Screw, self drilling, 6x1"flat, 100 pcs 2
815206900 Screw, security bolt, M8x20 100
815305500 Washer, flat, 100
815801001 ("¼) Cable clamp, black,100 pcs 2
815805802 Nirosta wire, 25pcs 2
815806001 Clamp-coil holder, 100 pcs 3
815806400 Band, Lok-Tie BL213, 7.9x482mm 50
M8/EXT=20mm/1 2mm
NOTES
1. For cases where fuel inlet neck is short, use the
provided stainless wire; otherwise use the clamp
band
2. If the coil/ID chip cannot be secured using
wires/clamp bands/screws, use Super Glue and a
fast activation accelerator. Cover the device with
a dual component adhesive (such as Epoxy).
The following adhesive substances are recommended for use:
1. SuperGlue, Cyanoacrylate- CA01, HOLDTITE
2. Glue, Acrylic, ST3294, high VEL. Black, HOLDTITE
3. Surface cleaning solution
4. Activator, pronto, 60ml (3M)
Figure 2-2. Light Vehicle Typical Installation Kit Components