Teac SS-CDR1 - Manual (Page 22)

4 − Preparations
22
TASCAM SS-CDR1
About the door lock
You can use the included Security Screw to lock the
CompactFlash card slot door.
Use a screwdriver to install or remove the Security Screw.
Removing the card
Before you remove the card, turn the power off or stop the
SS-CDR1’s operation. Never remove the card while record-
ing is in progress (while the CF indicator is blinking).
1 If the door is locked, use a screwdriver to remove
the door lock screw.
2 Open the CompactFlash card slot door.
3 Press the square button located at the right of the
card slot; the button will protrude.
4 Push the protruding square button, and the card
will be partially ejected.
5 Grasp the card and pull it out.
Inserting a CompactFlash card
In order to record or play back on the SS-CDR1, a
CompactFlash card must be inserted in the front panel
CompactFlash card slot.
TIP
You can insert a card at any time, regardless of
whether the power is on or off, and regardless of the
current device selection.
1 Open the door of the CompactFlash card slot.
2 Insert a CF card in the correct orientation.
Insert the card with its label facing up and its contacts
facing in.
CF
3 Close the door.
NOTE
If the slot door will not close, remove the card, press
the square button located at the right of the slot, and
then insert the card once again.
If the current device is CF, and the card was inserted while
the power was on, the display will indicate
MEDIA
READING
.
If you insert a card while the power is off, and then turn
the power on, the startup screen will appear and then the
display will indicate
MEDIA READING
.