Teac SS-CDR1 - Manual (Page 83)

17 − Specifications
TASCAM SS-CDR1
83
Storage disk CF card (CompactFlash card)
CD-R, CD-R-DA, CD-RW, CD-RW-DA (high speed CD-RW is supported)
Recording/playback formats MP3 (when using CF card or CD):
Sampling frequencies: 44.1 kHz, 48 kHz
Bit depth: 16 bit
Data rate: 64, 128, 192, 256, 320 kbps
WAV (recording only when using CF card):
Sampling frequencies: 44.1 kHz, 48 kHz
Bit depth: 16 bit
CD-DA (when using CD):
Sampling frequency: 44.1 kHz
Bit depth: 16 bit
Number of channels 2 channels (stereo)
1 channel (monaural)
Analog inputs Balanced XLR-3-31 equivalent
Nominal input level: +4 dBu
Maximum input level: +20 dBu
Minimum input level: -6 dBu or greater
Input impedance: 22 k Ø
Unbalanced RCA pin jack
Nominal input level: -10 dBV
Maximum input level: +6 dBV
Minimum input level: -20 dBV or greater
Input impedance: 22 k Ø
Analog Outputs Balanced XLR-3-32 equivalent
Nominal output level: +4 dBu
Maximum output level: +20 dBu (*1)
Output impedance: 100 Ø
Unbalanced RCA pin jack
Nominal output level: -10 dBV
Maximum output level +6 dBV
Output impedance: 200 Ø
Phones output Stereo phone jack (1/4")
45 mW + 45 mW or greater (THD+N: 0.1% or less, at 32 Ø load)
Digital input (COAXIAL) Connector: RCA pin jack (IEC- 60958-3 Consumer (S/PDIF))
Input sampling frequencies supported: 32 kHz – 48 kHz
Input impedance: 75 Ø (unbalanced)
Variable gain amount: -∞ – +10 dBFS
Digital output (COAXIAL) Connector: RCA pin jack
Supported signal format: IEC- 60958-3 Consumer (S/PDIF)
Output impedance: 75 Ø (unbalanced)
CONTROL I/O (RS-232C) connector
Communication protocol: Complies with RS-232C protocol specification 1.00
Connector: D-sub 9-pin connector
(PARALLEL) connector
Parallel control input/output
Connector: D-sub 25-pin connector
Maximum input voltage: +5.5 V
Minimum high level input voltage: +3.75 V
Maximum low level input voltage: +1.25 V
Output format: Open drain (maximum voltage 50 V, maximum current 50 mA)
Maximum low level output voltage: 0.5 V
17 − Specifications