Teac DP-32 - Manual (Page 31)

TASCAM DP-32
31
4 – Preparation
Inserting and removing SD cards
Inserting an SD card
Insert the SD card into the SD card slot on the rear panel
as shown in the illustration until it clicks into place.
NOTE
An SD card is already in the SD card slot when the unit is
shipped from the factory. If you want to use this card to
record and play tracks, there is no need to reinsert it.
Removing the card
Push the loaded card in gently to eject it.
CAUTION
• Always turn the power off (put in standby) before
removing an SD card.
• If you remove or insert an SD card when the power is
on, recorded data could be lost permanently.
• SD and SDHC cards that are at least 512 MB in size
can be used.
• A list of SD cards that have been confirmed to work
with this unit can be found on the TASCAM website
(http://tascam.com/).
About write-protected SD cards
SD cards have write-protect (lock) switches.
Unprotected Protected
When the protect switch is in the LOCK position, files
cannot be recorded or edited on the card. Slide the switch
away from the LOCK position if you want to record, erase
or otherwise change files on a card.
Powering the unit
As shown in the illustration, connect the included TASCAM
PS-1225L AC adaptor to the DC IN 12V jack.
TASCAM
PS-1225L
The bottom panel has a hook (cord holder) that can be
used to hold the AC adaptor cord in place. When using it,
wrap the cord around this hook to prevent it from being
disconnected during use.
CAUTION
• Use only the included TASCAM PS-1225L AC adaptor
and power cord. Use of a different AC adaptor could
cause malfunction, fire or electric shock.
• Be sure to use the included TASCAM PS-1225L AC
adaptor to supply power to this unit. Power cannot
be supplied to this unit by USB.
AC outlet
DC plug