Teac DP-32 - Manual (Page 44)

44
TASCAM DP-32
6 - Basic Recording
DIGITAL TRIM setting (track only)
Depending on the playback sound, EQ boosting could
cause distortion (digital clipping). If this happens, use the
DIGITAL TRIM to lower the playback level before the EQ.
1. Use the CURSOR (5/b/g/t) buttons to move the
cursor to the
DIGITAL TRIM
display area.
Digital trim
2. Turn the JOG/DATA dial to set the value.
Setting range:
-42dB
to
+6dB
(Default:
0dB
)
Sending signals to internal/external
effects
This unit has two external effect sends (EFF 1 and EFF 2)
and a send for the internal effects (INSERT EFFECT).
You can adjust send levels for each track. For details about
the built-in send effects, see "Send effects" on page 63.
Follow these procedures to enable use of these
effects.
1. Use the CURSOR (5/b/g/t) buttons to move the
cursor to the
SEND EFF 1/EFF 2
area.
Effect sends
2. Turn the JOG/DATA dial to enable the effect.
Options:
OFF
(default),
PRE
,
POST
PRE
This sends the track pre-fader signal to the effect
send bus. The effect send signal level is not affected
by the track fader.
POST
This sends the track post-fader signal to the effect
send bus. The effect send signal level is affected by
the track fader.
3. Use the SEND EFF 1/EFF 2 knobs to adjust the
external send levels.
Setting range:
0
to
127
(Default:
0
)
4. Use the SEND MASTER 1/MASTER 2 knobs to adjust
the internal send levels.
Setting range:
0
to
127
(Default:
0
)
Enabling insert effects
This unit has dynamic and guitar effects that can be
used as insert effects. For details about these effects, see
"Dynamic effects" on page 61 and "Guitar effects" on page
62.
1. Use the CURSOR (5/b/g/t) buttons to move the
cursor to the
INSERT EFFECT
area.
Insert effect
indicator
2. Turn the JOG/DATA dial to enable/disable the
insert effect.
Options
OFF:
INSERT EFFECT
indicator unlit (default)
ON:
INSERT EFFECT
indicator lit
Setting the stereo position
Use the PAN parameter to set the stereo position.
The full left value is
L63 , and the full right value is R63 .
The center position is shown by
C
.
PAN
Turn the PAN knob to adjust the stereo position.
Setting range:
L63
to
C
to
R63
(Default:
C
)