Verilink AS4000 (34-00244) Product Manual - Manual (Page 133)

Verilink AS4000 User Manual 9-1
Chapter
9
Octal DS-1/E1
The Octal DS-1/E1 module manages and combines up to 8 T1 or 8
E1 data streams (voice, data and video applications). Each T1/E1
link can be configured differently or the same as the others.
The Octal DS-1/E1 module presents console menus in which it is
called a T1/E1 module. In this document the AS4000 Octal DS-1/E1
module is always called a DS-1/E1 module.
NOTE: To meet FCC EMI and RFI regulations, a shielded twisted pair
cable must be used. The drain wire must be attached to one
of the two ground lugs available on the rear bezel. The drain
wire connection must be kept as short as possible. In
addition, the rear card must be secured to the chassis by
firmly tightening the card using the screws on the bezel.
Before You Begin
In order to view the menus associated with the Octal DS-1/E1
module, you must perform the following:
1. Place the Octal DS-1/E1 card in a slot in the equipment nest.
2. Configure the slot for module type: Octal T1/E1.
3. Confirm that the Configured Type and Actual Type noted on
the Node Summary Menu is Octal T1/E1.