Verilink AS4000 (34-00244) Product Manual - Manual (Page 56)

System Menus
4-12 Verilink AS4000 User Manual
• Filter by slot/port
• Starting slot/port/timeslot
Figure 4-9 Connection Filter Configuration Menu
Table 4-3 Connection Filter Configuration Menu
Change
Connection Menu
This menu is used to re-assign timeslots and change speed. This
screen is accessed from the Active Map Menu by positioning the
cursor on a particular Name field and pressing E
NTER . All other
parameters are read-only.
V V V Ve e e erilin rilin rilin rilink k k k Corp Corp Corp Corpo o o oratio ratio ratio ration n n n AS4011 AS4011 AS4011 AS4011 - Sy - Sy - Sy - Sys s s stem M tem M tem M tem Ma a a anager nager nager nager Help Help Help Help = [?] = [?] = [?] = [?]
Co Co Co Con n n nnecti necti necti nectio o o on Fil n Fil n Fil n Filt t t ter Co er Co er Co er Con n n nfigur figur figur figura a a ation tion tion tion
-- -- -- --- - - ------ ----- ----- ------ - - ------ ----- ----- ------ - - ------ ----- ----- ------ - - ------ ----- ----- ------ - - ----- ---- ---- ----
Filt Filt Filt Filte e e er Id. r Id. r Id. r Id.. . . ...... ..... ..... ...... . . .: Non : Non : Non : None e e e
Conn Conn Conn Conne e e ection ction ction ction Name. Name. Name. Name.. . . .: : : :
Slot Slot Slot Slot Numbe Numbe Numbe Number r r r..... ..... ..... ...... . . .: 0 : 0 : 0 : 0
Port Port Port Port Numbe Numbe Numbe Number r r r..... ..... ..... ...... . . .: 0 : 0 : 0 : 0
Time Time Time TimeS S S Slot N lot N lot N lot Nu u u umber. mber. mber. mber.. . . .: 0 : 0 : 0 : 0
Connection Name This field represents the 19-character connection name given by the user on the
Add New Connection screen.
Slot Number This field represents the source slot of a connection as entered on the Add New
Connection screen.
Port Number This field represents the port of a connection, as entered on the Add New
Connection screen. This would be a specific T1 in the aggregate of a T3 module,
or a physical port in the case of other types of modules.
Timeslot Number This field allows selection of a connection based on the DS0s used.