Visara 410 - Manual (Page 16)

2-2 707027-002
Chapter 2: Unpacking the Visara
Connecting the Cables
Refer to the diagram of the back panel. The icons above the connectors
designate their function.
POWER 100-240 VAC input at 47-63Hz
CRT VGA monitor connector
L-OUT Audio output jack
L-IN Audio input jack (not supported)
MIC Microphone input (not supported)
COM 1 Serial port 1
USB Universal serial bus connector (not supported)
PARALLEL Parallel printer port
LAN Ethernet connector 10/100
KB Keyboard connector
MSE Mouse connector
Before connecting power to the system unit, confirm that the power switch
on the front is in the off (out) position. Connect the power cord to the
Visara system unit before plugging the power cord into an electrical outlet.
Before plugging the monitor into an electrical outlet, connect the video
cable from the monitor to the Visara system unit.
Next, connect the keyboard and mouse to the system unit. Be careful that
you plug each into the correct connector since they both use the same
type of connector.