Visara 410 - Manual (Page 84)

Appendix C-4
Appendix C: Dialup
707027-002
Framing Protocol
• PPP: Select this option to use point-to-point protocol to the remote
host.
• SLIP: Select this option to use serial line interface protocol to the
remote host.
• RAS (Async NetBEUI): Select this option if dialing a RAS Server
running Windows NT3.1 or Windows for Workgroups 3.11
Authentication
• Accept any authentication including clear text: Select this option if
you are not concerned with passwords or dialing a non-Microsoft host.
• Accept only encrypted authentication: Select this option if dialing a
non-Microsoft host and do not want clear text passwords to be seen on
the communications line.
• Accept only Microsoft encrypted authentication: Select this option if
dialing a Microsoft host and the Microsoft MS-CHAP authentication
is to be used.
Modem / Port Setup
This tab pertains to the settings for the communications port COM1. If
connected to a modem, the default settings (Baud Rate = 19200, Parity =
None, 8 Data bits, 1 Stop bit,) should be sufficient.
• Flow Control:
Hardware: Uses RTS/CLS handshake to control the flow
of data between the modem and Visara. The
cable between the modem and the Visara
needs to support hardware flow control. This
is the default setting.
Software: Uses XON/XOFF handshake to control the
flow of data between the modem and Visara.
None: There is no handshake between the modem
and the Visara.