ATL Telecom IP300S - Manual (Page 61)

IP SIP Phone v2 User’s Guide Mar. 2005
[61/100]
v=0
o=m000dc300051 0 0 IN IP4 192.168.3.5
To configure the access code:
a. 【 】 Press FUNC 【 】 + # to activate menu.
b. Go to submenu “5. Preferences” / “7.Dial Plan / “4. Call Command” / “2.
Anonymous Call”.
c. Enter your customized CLIR access code, following the destination number:
C L I R A c c e s s C o d e
* 6 7
Note: Once the CLIR activation code is detected, the RED channel LED (【 】 A/B Call
will be on (instead of the green one) to remind user that CLIR is currently on. To
cancel CLIR, you may hang on then restart the whole dial process or alternatively,
you may enter the CLIP activation code to counter CLIR.
System default activation code for CLIR is “*67”, and “*82” for CLIP.
10.8. Message alert
After sending an instant message or receiving a new message, the phone will play an
auditable tone to remind user. You can configure the phone whether the auditable tone should be
played or not.
a. Press 【 】 FUNC + 【 】 # to activate menu.
b. Go to submenu “5. Preferences” / “8.Message Alert”.
1 . E n a b l e d .
2 . D i s a b l e d
c. Alternatively, you may go to web page 『IP SIP Phone』 / 『Preferences』=> “Message
Alert” to configure it.
System default is enabled
10.9. Auto-Answer
If auto-answer feature is enabled when an incoming call arrives, the phone-set will play
distinguished auditable tone shortly, then answer the call by turning on speaker-phone (or headset
if it is enabled) on idle mode; otherwise proceed as a normal incoming call.
By idle, it means the phone-set is either engaging in no calls or putting a call on hold.
IP SIP Phone implements various ways to support auto-answer features:
i. Server-side invoked auto-answer for urgent calls:
Use of a private header “P-Auto-answer” in the initial INVITE message for the server-side
invoked auto-answer extension:
a. P-Auto-answer: normal
z Respond a “486 Busy Here” if all lines are occupied.