ATL Telecom IP300S - Manual (Page 62)

IP SIP Phone v2 User’s Guide Mar. 2005
[62/100]
z Otherwise, auto-answer (1) this incoming call.
b. P-Auto-answer: urgent
z Dropped an inactive call if all lines are occupied.
z Put any on-going calls to hold and auto-switch to an available line if not idle.
z auto-answer
(1) the newly arrived call.
c. P-Auto-answer: imperious
z Identical to “P-Auto-answer: urgent” except that the phone-set will
auto-answer this call even the do-not-disturb (DND) or all-calls-forward feature
has been activated.
Note, the header, “P-Auto-Answer”, and its keyword, “normal”, “urgent” or “imperious”, are
all case-sensitive.
ii. Phone-set locally configured to auto-answer all incoming calls unconditionally (suitable for
attendant in call center service).
a. Unconditionally auto-answer all incoming calls on idle mode can be achieved by either
configuring the global phone-set setting and/or map the auto-answer feature as a
programmable key.
b. To configure the global phone-set setting for auto-answer:
z 【 】 Press FUNC 【 】 + # to activate menu.
z Go to submenu 『5. Preferences』 / 『9.Auto-Answer』.
1 . E n a b l e d .
2 . D i s a b l e d
System default is Disabled
c. Alternatively, you may configure this system-wide feature from web page 『IP SIP
Phone』 / 『Preferences』 => “Auto Answer”.
d. If you have mapped one of your DSS keys to “Auto-Answer”, press this DSS to toggle
auto-answer mode. Once enabled, the corresponding red LED of mapped DSS key will be
on, and the phone will auto-answer
(1)
all incoming calls arrive on idle mode. Besides,
unmap this DSS feature will turn off auto-answer configuration as well.
iii. Auto-Answer incoming calls arrive on specific registered SIP address-of-records.
For each service domain, you can configure to auto-answer all incoming calls to this SIP
account (<FROM> header in the initial INVITE message). This is particularly useful for
IP-PBX to implement broadcast feature. Alternatively this feature is also useful when the user
have 2 SIP accounts (or more), one for public and one for private use only, and he/she wants
to auto-answer all calls to his/her private account.
To configure the account-specific auto-answer feature:
z 【 】 【 】 Press FUNC + # to activate menu.
z Go to submenu 『6. Network』/『2.SIP Settings』/『2.Service Domain』/『N -th