H3C Technologies H3C WX3000 Series Unified Switches - Manual (Page 138)

16-10
# Create manual aggregation group 1.
<device> system-view
[device] link-aggregation group 1 mode manual
# Add GigabitEthernet 1/0/1 through GigabitEthernet 1/0/3 to aggregation group 1.
[device] interface GigabitEthernet1/0/1
[device-GigabitEthernet1/0/1] port link-aggregation group 1
[device-GigabitEthernet1/0/1] interface GigabitEthernet1/0/2
[device-GigabitEthernet1/0/2] port link-aggregation group 1
[device-GigabitEthernet1/0/2] interface GigabitEthernet1/0/3
[device-GigabitEthernet1/0/3] port link-aggregation group 1
2) Adopting static LACP aggregation mode
# Create static aggregation group 1.
<device> system-view
[device] link-aggregation group 1 mode static
# Add GigabitEthernet 1/0/1 through GigabitEthernet 1/0/3 to aggregation group 1.
[device] interface GigabitEthernet1/0/1
[device-GigabitEthernet1/0/1] port link-aggregation group 1
[device-GigabitEthernet1/0/1] interface GigabitEthernet1/0/2
[device-GigabitEthernet1/0/2] port link-aggregation group 1
[device-GigabitEthernet1/0/2] interface GigabitEthernet1/0/3
[device-GigabitEthernet1/0/3] port link-aggregation group 1
3) Adopting dynamic LACP aggregation mode
# Enable LACP on GigabitEthernet 1/0/1 through GigabitEthernet 1/0/3.
<device> system-view
[device] interface GigabitEthernet1/0/1
[device-GigabitEthernet1/0/1] lacp enable
[device-GigabitEthernet1/0/1] interface GigabitEthernet1/0/2
[device-GigabitEthernet1/0/2] lacp enable
[device-GigabitEthernet1/0/2] interface GigabitEthernet1/0/3
[device-GigabitEthernet1/0/3] lacp enable
Note that, the three LACP-enabled ports can be aggregated into a dynamic aggregation group to
implement load sharing only when they have the same basic configuration (such as rate and duplex
mode and so on).