H3C Technologies H3C WX3000 Series Unified Switches - Manual (Page 545)

51-9
Enabling system information display on the console
After setting to output system information to the console, you need to enable the associated display
function to display the output information on the console.
Follow these steps to enable the system information display on the console:
To do… Use the command… Remarks
Enable the debugging/log/trap
information terminal display
function
terminal monitor
Optional
Enabled by default.
Enable debugging information
terminal display function
terminal debugging
Optional
Disabled by default.
Enable log information terminal
display function
terminal logging
Optional
Enabled by default.
Enable trap information terminal
display function
terminal trapping
Optional
Enabled by default.
Make sure that the debugging/log/trap information terminal display function is enabled (use the
terminal monitor command) before you enable the corresponding terminal display function by using
the terminal debugging, terminal logging, or terminal trapping command.
Setting to Output System Information to a Monitor Terminal
System information can also be output to a monitor terminal, which is a user terminal that has login
connections through the AUX, VTY, or TTY user interface.
Setting to output system information to a monitor terminal
Follow these steps to set to output system information to a monitor terminal:
To do… Use the command… Remarks
Enter system view system-view —
Enable the information center info-center enable
Optional
Enabled by default.
Enable system information
output to Telnet terminal or
dumb terminal
info-center monitor channel
{ channel-number | channel-name }
Optional
By default, the device outputs
log/debugging/trap information to a
user terminal through information
channel 1.
Configure the output rules of
system information
info -center source { modu-name |
default } channel { channel-number |
channel -name } [ { log | trap | debug }
{ level severity | state state } ]*
Optional
Refer to
Table 51-4 for the default
output rules of system information.