H3C Technologies H3C WX3000 Series Unified Switches - Manual (Page 604)

58-25
# Set the probe timeout time to 30 seconds.
[device-hwping-administrator-snmp] timeout 30
# Start the test.
[device-hwping-administrator-snmp] test-enable
# Display test results
[device-hwping-administrator-snmp] display hwping results administrator snmp
HWPing entry(admin administrator, tag snmp) test result:
Destination ip address:10.2.2.2
Send operation times: 10 Receive response times: 10
Min/Max/Average Round Trip Time: 9/11/10
Square-Sum of Round Trip Time: 983
Last complete test time: 2000-4-3 8:57:20.0
Extend result:
SD Maximal delay: 0 DS Maximal delay: 0
Packet lost in test: 0%
Disconnect operation number: 0 Operation timeout number: 0
System busy operation number: 0 Connection fail number: 0
Operation sequence errors: 0 Drop operation number: 0
Other operation errors: 0
[device-hwping-administrator-snmp] display hwping history administrator snmp
HWPing entry(admin administrator, tag snmp) history record:
Index Response Status LastRC Time
1 10 1 0 2000-04-03 08:57:20.0
2 10 1 0 2000-04-03 08:57:20.0
3 10 1 0 2000-04-03 08:57:20.0
4 10 1 0 2000-04-03 08:57:19.9
5 9 1 0 2000-04-03 08:57:19.9
6 11 1 0 2000-04-03 08:57:19.9
7 10 1 0 2000-04-03 08:57:19.9
8 10 1 0 2000-04-03 08:57:19.9
9 10 1 0 2000-04-03 08:57:19.8
10 10 1 0 2000-04-03 08:57:19.8
For detailed output description, see the corresponding command reference.
TCP Test (Tcpprivate Test) on the Specified Ports
Network requirements
Both the HWPing client and the HWPing server are WX3000 series devices. Perform a HWPing
Tcpprivate test to test time required to establish a TCP connection between this end (Switch A) and the
specified destination end (Switch B), with the port number set to 8000.
Network diagram
Figure 58-8 Network diagram for the Tcpprivate test
Switch A Switch B
HWPing Client
IP network
10.1.1.1/8 10.2.2.2/8
HWPing Server