H3C Technologies H3C WX3000 Series Unified Switches - Manual (Page 613)

59-4
Figure 59-2 Network diagram for static DNS configuration
10.1 .1.1/24
10.1.1. 2/ 24
host.com
Host
Switch
Configuration procedure
# Configure a mapping between host name host.com and IP address 10.1.1.2.
<device> system-view
[device] ip host host.com 10.1.1.2
# Execute the ping host.com command to verify that the device can use static domain name resolution
to get the IP address 10.1.1.2 corresponding to host.com.
[device] ping host.com
PING host.com (10.1.1.2): 56 data bytes, press CTRL_C to break
Reply from 10.1.1.2: bytes=56 Sequence=1 ttl=127 time=3 ms
Reply from 10.1.1.2: bytes=56 Sequence=2 ttl=127 time=3 ms
Reply from 10.1.1.2: bytes=56 Sequence=3 ttl=127 time=2 ms
Reply from 10.1.1.2: bytes=56 Sequence=4 ttl=127 time=5 ms
Reply from 10.1.1.2: bytes=56 Sequence=5 ttl=127 time=3 ms
--- host.com ping statistics ---
5 packet(s) transmitted
5 packet(s) received
0.00% packet loss
round-trip min/avg/max = 2/3/5 ms
Dynamic Domain Name Resolution Configuration Example
Network requirements
As shown in Figure 59-3 , Switch serving as a DNS client uses dynamic domain name resolution to
access the host at 3.1.1.1/16 through its domain name host. The DNS server has the IP address
2.1.1.2/16. The DNS suffix is com.
Figure 59-3 Network diagram for dynamic DNS configuration
2.1.1.2/16
2.1.1.1
DNS server
Switch
DNS client
1.1.1/16
host. com
IP network
Host
/16 1. 3.1.1.1/ 16
Configuration procedure