H3C Technologies H3C Intelligent Management Center - Manual (Page 117)

108
{
Make sure the new B-VLAN and the old B-VLAN are mapped to different ECT algorithm
indexes.
5. Click OK.
6. When ECT migration is completed, verify the SPB service state.
7. If the SPB service is in an exceptional state, follow the procedure described in " Changing the
state of an SPB service from abnormal to normal " to resolve the problem.
Monitoring ACs
Attachment circuits are physical or logical links that connect customer sites to BEB devices.
You can use the VFM to monitor the connectivity between the SPB network and customer sites.
Viewing the AC list
1. Click the Service tab.
2. From the navigation tree, select VAN Fabric Manager > LAN Configuration > SPB.
3. Click the AC List tab.
AC List contents
{
Refresh—Click this link to refresh the AC list.
{
Device Name—BEB to which the AC is attached. By default, this field displays the device label
and the device IP address. The device label is assigned in the IMC Platform. The device IP
address is the IP address used when the device was added to the IMC Platform. For more
information about device details, see H3C IMC Base Platform Administrator Guide.
{
Interface Description—Interface type and number. Click an interface description to view its
interface details. For information about interface details, see H3C IMC Base Platform
Administrator Guide.
{
Customer Site Name—Customer site to which the AC is connected. To change a customer site
name, click the customer site name.
{
SPB service—SPB service assigned to the AC. To view the SPB service topology and details,
click the SPB service name. For more information about SPB service topology and details, see
" Viewing the topology and details of an SPB service ."
{
Details—Click the View Details icon to view AC details.
Querying ACs
1. Access the SPB page.
2. Use one of the following methods:
{
To perform a quick query, enter a partial or complete device label in the query field, and click
the Query icon
.
{
To perform an advanced query, click the Expand icon next to the query field, specify
query criteria, and then click Query.
Query criteria include the following items:
− Device Label—Enter a partial or complete device label.