Modifying trill configuration of an interface – H3C Technologies H3C Intelligent Management Center User Manual
Page 94
85
{
Hello Multiplier—Specify the Hello multiplier. The adjacency holding time is obtained by
multiplying the Hello interval by the Hello multiplier. The RB advertises the adjacency holding
time to neighbors through Hello frames. If a neighbor does not receive any Hello frame from
the RB before the adjacency holding time expires, it removes the TRILL adjacency with the RB.
{
Inhibition Time—Specify the inhibition time of the RB. When the RB detects that a root bridge
change occurs on a link or that the AVF advertised by other RBs conflicts with the local AVF, the
RB inhibits the local AVF for a certain time to avoid loops. When the inhibition timer expires, if
the RB is still the AVF of the VLAN, the RB restores the role of the AVF.
{
CSNP Interval—Specify the CSNP interval. On a broadcast network, the DRB advertises
CSNPs at the CSNP interval to perform network-wide LSDB synchronization.
{
Minimum LSP Interval (Milliseconds)—Specify the minimum LSP interval. RBs periodically
advertise LSPs to avoid frequent LSP aging on the network.
7.
Click OK.
8.
Click Back to go back to the TRILL Interface List page.
Modifying TRILL configuration of an interface
1.
Access the RB List page.
2.
Click the Operation icon
for the RB.
3.
Select Interface List from the shortcut menu.
The TRILL Interface List page displays all interfaces of the RB.
4.
Click the Modify icon
for the interface whose TRILL configuration you want to modify.
The Modify Interface page appears.
5.
Do one of the following:
{
To enable TRILL on the interface, select Yes from the Enable TRILL Interface list, and configure
the TRILL parameters as needed. For more information, see "
."
{
To disable TRILL on the interface, select No from the Enable TRILL Interface list.
6.
Click OK.