H3C Technologies H3C Intelligent Management Center - Manual (Page 47)

38
{
802.1p Priority—Enter the 802.1p priority to be reset for FCoE and FIP frames.
{
Local Precedence—Enter the local precedence to which the 802.1p priority is mapped. A local
precedence value corresponds to a WRR queue number.
3. Click OK.
Deploying global DCBX parameters to FCoE switches
If the operator has configured global DCBX parameters separately for an FCoE switch, the configured
global DCBX parameters are deployed.
If the operator has not configured global DCBX parameters separately for an FCoE switch, the default
global DCBX parameters are deployed.
To deploy global DCBX parameters to FCoE switches:
1. In the FCoE switch list, select one or more switches.
2. Click Configure DCBX.
3. Select Deploy DCBX from the menu that appears.
After global DCBX parameters are deployed, VFM automatically synchronizes the FCoE switches.
After synchronization, the DCBX column for the switch displays
. This indicates that global DCBX
parameters have been deployed and they are consistent in VFM and on the switch.
Undeploying global DCBX parameters from FCoE switches
Perform this task to undeploy the global DCBX parameters that have been deployed to FCoE switches.
To undeploy global DCBX parameters from FCoE switches:
1. In the FCoE switch list, select one or more switches.
2. Click Configure DCBX.
3. Select Undeploy DCBX from the menu that appears.
After global DCBX parameters are undeployed, VFM automatically synchronizes the FCoE switches.
After synchronization, the DCBX column for the switch displays , indicating that global DCBX
parameters are not deployed and they are inconsistent on the switch and in VFM.
Viewing CEE interfaces
1. In the FCoE switch list, click the link for the target switch.
2. Click the CEE Interface tab. The CEE interface list appears.
CEE interface list buttons
{
State Setting—This button contains two options: Enable Port and Disable Port, which can be
used to enable and disable a CEE interface, respectively.
{
Configure DCBX—This button contains two options: Deploy DCBX and Undeploy DCBX. The
Deploy DCBX option allows you to deploy interface DCBX parameters in VFM to CEE
interfaces (see " Deploying DCBX parameters to CEE interfaces "). The Undeploy DCBX option
allows you to undeploy the DCBX parameters that have been deployed to CEE interfaces (see
" Undeploying DCBX parameters from CEE interfaces ").
NOTE:
DCBX parameters in VFM include global DCBX parameters and interface DCBX parameters.
Global DCBX parameters take effect on a switch globally, and interface DCBX parameters take
effect on a specific interface.