HEIDENHAIN ND 1100 - Manual (Page 21)

2-1
Chapter 2
Operation
This chapter describes how to operate the QC100. Instructions
will show typical LCD screen contents. This chapter includes:
• Measuring with the QC100
page 2-2
• Probing and targeting page 2-2
• Datum page 2-2
• Front panel controls and LCD screens page 2-3
• Front panel keys page 2-3
• LCD menus page 2-8
• Preparing for operation page 2-9
• Performing measurements page 2-15
The contents of LCD screens will reflect a system using X and Y
axis encoders configured with factory default settings. Your sys-
tem may also include Z and/or Q axis encoders and might have
slightly different defaults and operating parameters, however the
instructions in this chapter are generic and will apply equally well
to all systems.