HEIDENHAIN ND 1100 User Manual

Page 30

Advertising

Chapter 2

Operation

2-10

Very little preparation is required before operating the QC100.
Connections to the system should be checked and power applied.

Checking connections

Checking connections
Perform a routine inspection of all connections to the digital read-
out system. Connections should be clean and tight. Cables should
be located away from moving objects and should not create trip-
ping hazards.

Cables connected to the parallel and serial (RS232) output ports
should be shielded and should be terminated and firmly connected
on both ends.

CAUTION

UTION

Never connect electrical cables to the system when the power

Never connect electrical cables to the system when the power
is on.

is on.

Applying power

Applying power
To apply power, press the power
switch located at the back of the
enclosure to ON (1). The sys-
tem will initialize and display the
power-up screen.

Press any key on the front panel
to complete the system initial-
ization. The DRO screen will be
displayed showing the current
positions of encoders on each
axis.

NOTE

NOTE
If the encoders used with your system include reference marks,

If the encoders used with your system include reference marks,

If the encoders used with your system include reference marks,
you may be instructed to cross the reference marks on each

you may be instructed to cross the reference marks on each

you may be instructed to cross the reference marks on each
axis before the DRO screen is displayed.

axis before the DRO screen is displayed.

Getting started

Advertising

Popular Brands

Popular manuals