HEIDENHAIN ND 1100 - Manual (Page 26)

Chapter 2 Operation
2-6
Softkey menus
Setup menu
Extra menu
An important collection of con-
figuration, measurement and
display functions can be made
available by activating the
Softkey Menu
Softkey Menu Softkey Menu Softkey Menu Softkey Menu functions. These
functions are contained in the Setup
Setup Setup Setup Setup and Extra Extra Extra Extra Extra menus menus menus menus menus which are
displayed by pressing the Menu softkey Menu softkey Menu softkey Menu softkey Menu softkey.
The Setup menu Setup menu Setup menu Setup menu Setup menu is used only by supervisors and dealer represen-
tatives to configure the advanced measurement, display and com-
munication parameters of the QC100 system. Use of the Setup
menu is discussed for supervisors and dealer representatives later
in Chapter 4: Setup.
NOTE NOTE NOTE NOTE NOTE
Operators should not attempt to use the Setup menu to change
Operators should not attempt to use the Setup menu to change Operators should not attempt to use the Setup menu to change Operators should not attempt to use the Setup menu to change Operators should not attempt to use the Setup menu to change
system configurations.
system configurations. system configurations. system configurations. system configurations.
The Extra menu Extra menu Extra menu Extra menu Extra menu provides access
to functions that control mea-
suring, communication and dis-
play parameters. The Extra
Extra Extra Extra Extra
menu menu menu menu menu is displayed by pressing
the Extra softkey
Extra softkey Extra softkey Extra softkey Extra softkey.
DMS/DD DMS/DD DMS/DD DMS/DD DMS/DD
Toggles the display of angles
between degrees, minutes and
seconds and decimal degrees.
Zero 2 Zero 2 Zero 2 Zero 2 Zero 2
Zeroes the absolute and incremental datums.
NOTE NOTE NOTE NOTE NOTE
The Extra menu includes functions that zero all axes when the
The Extra menu includes functions that zero all axes when the The Extra menu includes functions that zero all axes when the The Extra menu includes functions that zero all axes when the The Extra menu includes functions that zero all axes when the
QC100 system includes a Z and/or Q axis.
QC100 system includes a Z and/or Q axis. QC100 system includes a Z and/or Q axis. QC100 system includes a Z and/or Q axis. QC100 system includes a Z and/or Q axis.
Send X Send X Send X Send X Send X
Sends the current X axis data displayed on the DRO screen to a
printer or computer.