Yaskawa CM012 DeviceNet Option Card - Manual (Page 7)

Installation 1-2
Installation Check Sheet
The following is a quick reference check list to install and configure the DeviceNet Option Card. Make a copy of this page and check off ;
each item as it is completed. For detailed information please refer to the detailed sections that follow.
1. † Unpack and Inspect.
Unpack the DeviceNet Option Card and verify that all components are present and undamaged.
Refer to the “Unpack and Inspect” section of this manual.
2. † Verify Drive Operation:
Refer to the “Verify Drive Operation” section of this manual for details.
3. † Install the DeviceNet Option Card on the drive:
Refer to the “Mount the DeviceNet Option Card” section of this manual for details.
4. † Connect the DeviceNet Option Card to the DeviceNet communication network:
Refer to the “Connect to the DeviceNet Option Card” section of this manual.
5. † Set the DeviceNet Option Card network address and baud rate:
Refer to the “Configure the DeviceNet Option Card” section of this manual for details.
6. † Apply power to the drive and check diagnostic and operation LED states:
Refer to the “Power-up Diagnostic LED Test Sequence” section of this manual for details.
Refer to the “Normal Operation LED States” section of this manual for details.
Verify that the drive is wired correctly by referring to the appropriate drive user and/or technical manual prior to applying power.
7. † Verify that the drive is on the network:
Refer to the “Verify that the Drive is on the Network” section of this manual for details.
Refer to the documentation included with the DeviceNet configuration utility supplied with the DeviceNet Master controller.
Verify that the drive appears on the DeviceNet network at the correct node address.
8. † Install the appropriate EDS file if desired.
Refer to the “EDS Files” section of this manual.
9. † Configure the drive on the network.
Refer to the “Configure the Drive on the Network” section of this manual.
10. † Configure the scanner.
Refer to the “Configure the Scanner” section of this manual.
11. † Finish the DeviceNet Option Card Installation:
Refer to the “Configure Drive Parameters” section of this manual for details.
Set parameters b1-01 and b1-02 to their appropriate values.
Dangerous voltages in excess of 400VDC (230V drives) or 800VDC
(460V drives) are present at the DC bus terminals of the drive.
WARNING!