Yaskawa E7 Drive User Manual - Manual (Page 13)

Physical Installation 1 - 3
Confirmations upon Delivery
Receiving Checks
Check the following items as soon as the Drive is received.
If there are any irregularities in the above items, contact the shipping company, the distributor or representative who sold the
Drive, or a Yaskawa office immediately.
The E7 is thoroughly tested at the factory. Any damages or shortages evident when the equipment is received must be reported
immediately to the commercial carrier that transported the material. Shipping damage is not covered by the Yaskawa warranty.
After unpacking and inspecting for damage, verify that internal wire connections have not come loose during shipment by spot
checking wire terminations with a screwdriver or the appropriate tool.
E7 Drive storage must be in a clean and dry location. Maintain the factory packaging and provide covering as needed to
protect the E7 from construction site dirt, water, debris and traffic prior to and during construction.
Nameplate Information
A nameplate is attached to the right side of each Drive. The following nameplate is an example for a standard Drive.
Fig 1.1 E7 Drive Nameplate
Table 1.2 Receiving Checks
Item Method
Has the correct model of Drive been
delivered? Check the model number on the nameplate on the right side of the Drive.
Reconcile with packing slip and/or order information.
Is the Drive damaged in any way?
Inspect the entire exterior of the Drive to see if there are any dents, scratches or
other damage resulting from shipping.
Are any screws or other components
loose?
Use a screwdriver or other tool to check for tightness.
Input Power Specifications
Output Power Specifications
Drive Model Number
Drive Enclosure and
Revision Code
Weight
Serial Number
UL File Number
Drive Spec Number
Output Power Rating
Input Power Rating
Note: The Drive Model Number and Drive Spec Number are required to completely identify a Drive.
TM_E7_01_07182008.book Page 3 Wednesday, July 23, 2008 2:35 PM