Yaskawa E7 Drive User Manual - Manual (Page 75)

Programming 5 - 1
Chapter 5
Basic Programming
This Manual contains descriptions of all user accessible parameters contained in the Drive.
Parameters are listed in alpha-numerical order. Parameter number and name, along with a
detailed description and its settings are described on the following pages.
A1 Initialization........................................................................... 5-2
b1 Sequence.............................................................................. 5-4
b2 DC Braking.......................................................................... 5-10
b3 Speed Search ..................................................................... 5-12
b5 PI Function.......................................................................... 5-16
b8 Energy Savings ................................................................... 5-25
C1 Accel/Decel ........................................................................ 5-26
d2 Reference (Speed Command) Limits.................................. 5-27
d3 Jump Frequencies............................................................... 5-28
E1 V/f Pattern........................................................................... 5-29
E2 Motor Setup ........................................................................ 5-32
F6 Com OPT Setup (applies only to the LonWorks option) ..... 5-33
H3 Analog Inputs ..................................................................... 5-34
L2 Momentary Power Loss Ride-thru Function........................ 5-40
L3 Stall Prevention ................................................................... 5-41
L4 Speed Command Loss Detection ....................................... 5-45
L5 Fault Restart ....................................................................... 5-46
L6 Torque Detection................................................................. 5-48
L8 Hardware Protection ........................................................... 5-50
o1 Monitor Configuration.......................................................... 5-52
o2 Key Selections .................................................................... 5-56
o3 Digital Operator Copy Function........................................... 5-58
T1 Auto-Tuning......................................................................... 5-61
TM_E7_01_07182008.book Page 1 Wednesday, July 23, 2008 2:35 PM