Yaskawa E7 Drive User Manual - Manual (Page 83)

Programming 5 - 9
b1-08 Run Command Selection During Programming
As a safety precaution, the Drive will not normally respond to a Run input when the digital operator is being used to adjust
parameters. If it is necessary that external Run commands be recognized even while the Drive is being programmed, set
b1-08= “1: Enabled”.
IMPORTANT
When switching from local mode to Auto mode when b1-07=“1: Accept Extrn Run” the Drive may start
unexpectedly if the Run command is already applied. Be sure all personnel are clear of rotating machinery
and electrical connections prior to switching between local mode and Auto mode.
Setting Description
0 Disabled (factory default)
1 Enabled
TM_E7_01_07182008.book Page 9 Wednesday, July 23, 2008 2:35 PM