Sflt, Test, Pass – Yaskawa DSD 406 User Manual
Page 60
Advertising
3
Operation
56
3/21/96
Self-Tune (PCU Parameter Measurement)
❏ When testing is complete, press the DATA/FCTN key to exit the PCU
parameter measurement routine and return to the "Function" level. The
SCDU displays:
❏ Severe faults can only be cleared by cycling power to the drive and replacing
the bad component if applicable. The SCDU displays the word ‘tESt’ while
it is performing the parameter measurements if there were no SEVERE
FAULTS when the ENTER key was pressed:
❏ Upon completion of the measurement, the SCDU will indicate the status of
the test. If an error occurred, the SCDU will display an appropriate fault
number. If all tests were completed properly, the SCDU displays ‘PASS’:
GREEN
DATA
sflt
GREEN
DATA
test
GREEN
DATA
pass
GREEN
DATA
997
Advertising
This manual is related to the following products: