Casio YA-W72M User Guide - Manual (Page 25)

25
Projecting a Computer Screen Image onto the Dot Screen
Note
z Do not perform the procedure below until you have completed all of the steps under:
“Preparing the Digital Pen” (page 10), “Installing the Software” (page 17), and “Setting Up the
Dot Screen, Projector, and Computer” (page 23).
z For detailed information about projector and computer operations, refer to the projector and
computer user documentation.
1.
Set up the projector in a location where it can project onto the dot screen.
2.
Use a cable to connect the projector’s image input terminal to the computer’s
video output terminal (RGB output, HDMI output, etc.)
3.
After checking to make sure that a Bluetooth adapter is connected to the
computer turn on the computer and projector.
z If you connect a Bluetooth adapter while your computer is running, you will need to perform
the steps below on your computer to restart DSPD.
4.
On the projector, adjust the zoom setting and adjust the location of the projector
so the image it is projecting fits within the dot screen area.
5.
On the projector, configure the required settings to specify video output from the
computer as the input source.
At this point you have completed all the steps required to prepare the Interactive Whiteboard for use.
In the next chapter, you will learn about the powerful features and functions provided by the
Interactive Whiteboard.
Important!
z Note that even if the projector is projecting an image of the computer screen onto the dot
screen, you will not be able to perform digital pen operations unless Interactive Whiteboard for
CASIO is running.
1 In your computer’s task tray, right-click the DSPD icon ( ). On the menu that appears,
click “Exit”.
2 Windows XP, Vista, 7:
On your computer, perform the following sequence:
Click [Start] 3 [All Programs] 3 [dnp] 3 [dspd] 3 [dspd].
Windows 8:
On the Start screen, click the [dspd] tile.
B