Casio YA-W72M User Guide - Manual (Page 85)

85
4.
The dot screen is ready for use after it is completely dry.
To clean the back of the dot screen
When cleaning the back of the dot screen, roll it on to the roller bit by bit and wipe the back. This
makes it possible to clean the back of the screen without creating wrinkles. To avoid getting dust or
other foreign matter on the surface of the dot screen, never allow it so come into direct contact with
the floor.
Note
z To clean the supplied melamine foam eraser, remove the cloth/sponge part from the plastic
case and wash it in a solution of water and a neutral detergent. After washing, allow the cloth/
sponge part to dry thoroughly before using it again.
Use the procedure below to stow the dot screen.
1.
Disconnect the safety hook.
2.
Pressing the roll against the surface where the dot screen is attached, roll up the
screen.
z Take care when rolling up the screen to ensure that it is straight and that there is no slack. To
remove crookedness and slack, unroll the screen onto a surface and then roll it back up again.
Trying to force the dot screen into position while it is rolled up can damage the screen.
3.
Carefully remove the rolled up screen from the surface.
z Maintain approximately the same amount of pressure on the roller against the surface until the
dot screen is completely rolled up. Failure to do so can cause the dot screen to fall from the
surface.
4.
Fold down the anti-slack wires on either end of the roll
and hook them on to the end bar hooks.
5.
Insert the rolled up screen in the screen case.
Stowing the Dot Screen