Casio YA-W72M User Guide - Manual (Page 28)

28
To perform calibration
1.
If IWB for CASIO is not running, double-click the Interactive Whiteboard for
CASIO icon on your computer desktop to start it up.
2.
Remove the cap from the digital pen.
3.
Project the screen image from the computer onto the dot screen.
z If there are multiple display devices (including projectors) connected to the computer, check if
the projector is the computer’s primary display device or secondary (or other) display device.
z If the projector is the computer’s primary display device, you can start calibration simply by
tapping the dot screen with the digital pen only. In this case, tap the dot screen with the digital
pen and then jump to step 7 of this procedure. Otherwise, proceed with step 4, below.
4.
In the computer’s task tray, click the Interactive Whiteboard for CASIO icon ( ).
5.
On the menu that appears, select “Calibration”.
6.
On the sub-menu that appears, select the display device (projector) that you
want to calibrate.
z If the projector is the only display device connected to the computer or if the projector is
connected to a laptop computer and an image of the laptop computer’s screen is being
projected, “A” will be the only option displayed on the sub-menu. In this case, select “A”.
z The sub-menu will appear when there are two display devices (for example, laptop computer
and projector, etc.) connected to the computer and the display device screen is expanded.
Select “A” if the projector is the primary display device, or “B” if it is the secondary display
device.
z Selecting the correct letter on the sub-menu will cause the letter to appear in the center of the
dot screen, along with a calibration mark in the upper left corner.
7.
Tap the center of the calibration mark once with the digital pen.
z The position (coordinates) of the location where you tapped will be recorded when you remove
the digital pen from the dot screen.
Note
z If the letter in the center of the dot screen is
different from the one you selected on the
“Calibration” sub-menu and no calibration
mark is displayed, it means that you selected
the wrong display device.
If this happens, click the close (
) button in
the lower right corner of the main toolbox and
perform this procedure again starting from
step 1.