ProSoft Technology 5201-DFNT-104C - Manual (Page 114)

Reference 104C Version 3 ♦ ProLinx Gateway
Protocol Manual IEC 60870-5-104 Client (Firmware v3.xx)
Page 114 of 139 ProSoft Technology, Inc.
August 4, 2011
8 Cmd Queue
Count This word contains the number of active commands in the command
queue for the driver. Up to 100 commands can be buffered in this
queue. These commands are transferred to the driver from the
mailbox interface.
9 to 10 Online Status This double word value contains a bit for each of the 4 potential
sessions in the module. If the bit is set for a session in the double
word, the station is online. If the bit is clear, the station is offline.
Use this value to determine if commands sent to the driver will have
a chance of succeeding.
11 Spare Reserved
12 SNTP Valid NTP time is valid (0=No, 1=Yes)
13 NTP Request Number of requests to NTP server
14 NTP Response Number of responses from NTP server
15 SNTP
Computation Number of times SNTP time computed
16 SNTP Set Number of times SNTP time set
17 NTP Timeout Number of NTP response timeouts
You can also copy the client status data to the module database through the
following parameter:
Follows below the contents of the status offset data block: