ProSoft Technology 5201-DFNT-104C - Manual (Page 126)

Reference 104C Version 3 ♦ ProLinx Gateway
Protocol Manual IEC 60870-5-104 Client (Firmware v3.xx)
Page 126 of 139 ProSoft Technology, Inc.
August 4, 2011
Transmission of Integrated totals
(Station- or object-specific parameter, mark "X" if function is only used in the
standard direction, "R" if only used in the reverse direction, and "B" if used in
both directions)
⌧
Mode A: Local freeze with spontaneous transmission
⌧ Mode B: Local freeze with counter interrogation
⌧ Mode C: Freeze and transmit by counter-interrogation commands
⌧ Mode D: Freeze by counter-interrogation command, frozen values
reported spontaneously
⌧
Counter read
⌧ Counter freeze without reset
⌧ Counter freeze with reset
⌧ Counter reset
⌧
General request counter
⌧ Request counter group 1
⌧ Request counter group 2
⌧ Request counter group 3
⌧ Request counter group 4
Parameter loading
(Object-specific parameter, mark "X" if function is only used in the standard
direction, "R" if only used in the reverse direction, and "B" if used in both
directions)
⌧
Threshold value
⌧ Smoothing factor
⌧ Low limit for transmission of measured value
⌧ High limit for transmission of measured value
Parameter activation
(Object-specific parameter, mark "X" if function is only used in the standard
direction, "R" if only used in the reverse direction, and "B" if used in both
directions)
⌧
Act/deact of persistent cyclic or periodic transmission of the addressed
object