ProSoft Technology 5201-DFNT-104C - Manual (Page 120)

Reference 104C Version 3 ♦ ProLinx Gateway
Protocol Manual IEC 60870-5-104 Client (Firmware v3.xx)
Page 120 of 139 ProSoft Technology, Inc.
August 4, 2011
Process information in control direction
(Station-specific parameter, mark each Type ID 'X" if it is only used in the
standard direction, "R" if only used in the reverse direction, and "B" if used in
both directions)
⌧
<45> := Single command C_SC_NA_1
⌧ <46> := Double command C_DC_NA_1
⌧ <47> := Regulating step command C_RC_NA_1
⌧ <48> := Set point command, normalized value C_SE_NA_1
⌧ <49> := Set point command, scaled value C_SE_NB_1
⌧ <50> := Set point command, short floating point value C_SE_NC_1
⌧ <51> := Bitstring of 32 bit C_BO_NA_1
⌧ <58> := Single command with time tag CP56Time2a C_SC_TA_1
⌧ <59> := Double command with time tag CP56Time2A C_DC_TA_1
⌧ <60> := Regulating step command with time tag CP56Time2A
C_RC_TA_1
⌧ <61> := Set point command, normalized value with time tag
CP56Time2A C_SE_TA_1
⌧
<62> := Set point command, scaled value with time tag CP56Time2A
C_SE_TB_1
⌧ <63> := Set point command, short float value with time tag
CP56Time2A C_SE_TC_1
⌧
<64> := Bitstring of 32 bit with time tag CP56Time2A C_BO_TA_1
Either the ASDUs of the set <45>-<51> or of the set <58>-<64> are used.
System information in monitor direction
(Station-specific parameter, mark "X" if used)
⌧
<70> := End of initialization M_EI_NA_1
System information in control direction
(Station-specific parameter, mark each Type ID 'X" if it is only used in the
standard direction, "R" if only used in the reverse direction, and "B" if used in
both directions)
⌧
<100> := Interrogation command C_IC_NA_1
⌧ <101> := Counter interrogation command C_CI_NA_1
⌧ <102> := Read command C_RD_NA_1
⌧ <103> := Clock synchronization command C_CS_NA_1
⌧ <105> := Reset process command C_RP_NC_1
⌧ <107> := Test command with time tag CP56Time2a C_TS_TA_1