NETGEAR AV Line M4250 GSM4210PX 8-Port Gigabit PoE+ Compliant Managed AV Switch with SFP (220W) - Manual (Page 422)

Delete a static IPv4 PIM rendezvous point configuration
You can delete a static IPv4 PIM rendezvous point (RP) configuration that you no longer
need for a group.
To delete a static IPv4 PIM RP configuration for a group:
1. Launch a web browser.
2. In the address field of your web browser, enter the IP address of the switch.
The login page displays.
3. Click the Main UI Login button.
The main UI login page displays in a new tab.
4. Enter admin as the user name, enter your local device password, and click the Login
button.
The first time that you log in, no password is required. However, you then must
specify a local device password to use each subsequent time that you log in.
The System Information page displays.
5. Select Routing > Multicast > PIM > Static RP Configuration.
The Static RP Configuration page displays.
6. Select the check box for the static RP.
7. Click the Delete button.
Your settings are saved. The static RP configuration is deleted for the group.
8. To save the settings to the running configuration, click the Save icon.
Static multicast routes for IPv4 addresses
If a multicast routing protocol such as PIM-SM or PIM-DM is enabled and configured,
multicast routes are built dynamically. However, you can also configure one or more
static IPv4 multicast routes. A static route can facilitate the processing of multicast traffic
when a neighboring reverse-path forwarding (RPF) router is located between the switch
and the multicast source.
Configure static multicast routes for IPv4 addresses
You can add a new or change an existing static IPv4 multicast route.
Main User Manual 422 Configure Multicast Routing
AV Line of Fully Managed Switches M4250 Series Main User Manual