NETGEAR AV Line M4250 GSM4210PX 8-Port Gigabit PoE+ Compliant Managed AV Switch with SFP (220W) - Manual (Page 48)

network traffic on the switch ports and cannot be switched or routed to the
operational network.
• Management VLAN interface: The management VLAN is the logical interface used
for in-band connectivity with the switch over any of the switch's network interfaces.
To access the switch over a network you must first configure an IP address and subnet
mask for the switch.
• Optional single management interface: By default, you can use any of the switch's
network interfaces as the management interface. However, you can restrict IPv4
management to one specific network interface.
Configure the IPv4 service port
You can configure network information on the IPv4 service port, also referred to as the
out-of-band (OOB) port. The service port is a dedicated Ethernet port for out-of-band
management of the switch. Traffic on this port is segregated from operational network
traffic on the switch ports and cannot be switched or routed to the operational network.
By default, no IP address is set for the OOB port, but its DHCP client is enabled so that
the port can receive an IP address from a DHCP server in your network. If the OOB port
does not receive an IP address from a DHCP server in your network, the IP address for
the port is set to 192.168.0.239 with 255.255.255.0 as the subnet mask. The same occurs
if you connect the OOB port directly to a computer and reboot the switch.
To configure the IPv4 service port:
1. Launch a web browser.
2. In the address field of your web browser, enter the IP address of the switch.
The login page displays.
3. Click the Main UI Login button.
The main UI login page displays in a new tab.
4. Enter admin as the user name, enter your local device password, and click the Login
button.
The first time that you log in, no password is required. However, you then must
specify a local device password to use each subsequent time that you log in.
The System Information page displays.
5. Select System > Management > Management Interfaces > IPv4 Service Port
Configuration.
The IPv4 Service Port Configuration page displays.
6. Select a Service Port Configuration Protocol radio button:
Main User Manual 48 Configure Switch System
Information
AV Line of Fully Managed Switches M4250 Series Main User Manual