Vaddio DocCAM 20 HDBT OneLINK Bridge System - Manual (Page 34)

Web Interface
The OneLINK device provides a web interface to allow configuration and administration using a browser.
The web interface allows you to:
n Set idle session behavior and passwords
n Manage streaming settings
n Add identifying information to the web interface
n Back up, reboot, reset, or update the device
n View information about the camera connection
n View network-related information
n View information about the device's firmware and current settings
Note
The OneLINK device is not a camera control device. To configure or operate the camera, use the
camera's web interface. Refer to the camera's documentation for details.
Note
The connected camera is configured separately from the OneLINK device. Changes to the OneLINK
device's configuration do not affect the configuration of the camera or other connected equipment. If you
need to change the way the camera is configured, log in to the camera's web interface.
Compatible Web Browsers
We have tested this product with these web browsers:
n Chrome®
n Firefox®
n Microsoft® Internet Explorer®
n Safari®
We test using the browser version available from the vendor at that time. Older versions of these
browsers are likely to work, and other browsers may also work.
Initial Device Set-Up and System Administration Tasks
When any Vaddio product is shipped from the factory, there is no admin password and the administrative
controls are not available. You will need to access the web interface and set the admin password. This
gives you access to the system administration tasks to define how the device behaves as an element of
your network.
Complete Manual for the OneLINK Bridge AV Interface
30