Vaddio DocCAM 20 HDBT OneLINK Bridge System - Manual (Page 60)

system reboot
Reboots the system either immediately or after the specified delay. Note that a reboot is required when
resetting the system to factory defaults (system factory-reset).
Synopsis system reboot [<seconds>]
Options <seconds> The number of seconds to delay the reboot.
Examples > system reboot
OK
>
The system is going down for reboot NOW! onelink-bridge-D8-80-39-62-
A7-C5
Reboots the system immediately.
> system reboot 30
Reboots the system in 30 seconds. The response appears at the end of the delay.
system factory-reset
Gets or sets the factory reset status. When the factory reset status is on, the OneLINK device resets to
factory defaults on the next reboot.
Note
This does not reset the camera.
Synopsis system factory-reset { get | on | off }
Options get Returns the camera's current factory reset
status.
on Enables factory reset on reboot.
off Disables factory reset on reboot.
Examples > system factory-reset get
factory-reset (software): off
factory-reset (hardware): off
OK
>
Returns the factory reset status.
This evaluates the most recent system factory-reset on or off command, if
one has been received, then reads the rear panel DIP switches and returns the
status
on if they are all in the down position.
> system factory-reset on
factory-reset (software): on
factory-reset (hardware): off
OK
>
Enables factory reset upon reboot.
Note
This command does not initiate a factory reset. The factory reset takes place on
the next reboot.
Complete Manual for the OneLINK Bridge AV Interface
56